Use these procedures to troubleshoot the LIN communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, inspect the CAN communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output (for LHD) |
| DTCs output (for RHD) |
No DTCs output
DTCs output (for LHD)
with Central Gateway ECU
without Central Gateway ECU
DTCs output (for RHD)
with Central Gateway ECU
without Central Gateway ECU
Using the GTS, inspect the LIN communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Refer to the Problem Symptoms Table.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Data List / Active Test
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT