87299
1.INSPECT WASHER HEATER RELAY (w/ Washer Nozzle Heater)
Remove the washser heater relay assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the washser heater relay assembly.