Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(When Using the Engine Support Bridge for AD Series Engine)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0256589 VACUUM PUMP(When Using the Engine Support Bridge for AD Series Engine) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(When Using the Engine Support Bridge for AD Series Engine)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.

Disconnect the vacuum hose from the vacuum pump.


b.
C261793C01
0.333,1.719 0.26,1.979 0.26,1.979 0.26,3 false 0.26,3 0.948,3 false 0.99,2.927 1.208,3.125 0.219,0.198 10 *a
*a Vacuum Gauge


Connect the hose of the vacuum gauge to the vacuum pump.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the negative pressure of the vacuum pump.

Standard pressure:

More than 87 kPa (650 mmHg, 25.6 in.Hg)


HINT:

If the result is not as specified, replace the vacuum pump.



e.

Remove the vacuum gauge from the vacuum pump.


f.

Connect the vacuum hose to the vacuum pump.