Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT › from 2016.08
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0050143 AIR CONDITIONING UNIT A

HEATING / AIR CONDITIONING  AIR CONDITIONING UNIT  DISASSEMBLY  


PROCEDURE

Hide 87710G 1.REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)

Hide 55906D 2.REMOVE NO. 2 HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

E269760

a.

Using a screwdriver with the tip wrapped with protective tape, detach the 3 claws and remove the No. 2 heater control cable sub-assembly.


Hide 55909A 3.REMOVE AND INSTALL AIRMIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

E269761

a.

Using a screwdriver with the tip wrapped with protective tape, detach the 3 claws and remove the air mix damper control cable sub-assembly.


Hide 87050C 4.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

a.
E265955

Remove the 3 screws and No. 1 air conditioning radiator damper servo sub-assembly.


Hide 87050D 5.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

a.
E260971

Remove the 3 screws and No. 2 air conditioning radiator damper servo sub-assembly.


Hide 87050E 6.REMOVE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

a.
E260969

Remove the 3 screws and No. 3 air conditioning radiator damper servo sub-assembly.


Hide 87107A 7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

a.
E265958

Remove the screw and clamp.


b.
E265959

Remove the heater radiator unit sub-assembly from the air conditioning radiator assembly as shown in the illustration.


Hide 88515 8.REMOVE COOLER EXPANSION VALVE

a.
E265960

Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.


Hide 88501 9.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

a.
E265961

Remove the 4 screws.


b.

Detach the 2 claws and 2 guides, and remove the lower heater case.


c.
E265962

Detach the clamp.


d.

Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor from the upper heater case.


e.

Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.