Home › Vehicle Interior › SEAT › SEAT MEMORY SWITCH › from 2016.08
RM3090E _58 Vehicle Interior _008433 SEAT _0058015 SEAT MEMORY SWITCH G

SEAT  SEAT MEMORY SWITCH  INSPECTION  


PROCEDURE

Hide 84927 1.INSPECT SEAT MEMORY SWITCH

a.

Check the resistance.

i.
B452646C01
1.979,2.448 2.531,2.448 true 0.885,2.448 1.438,2.448 true 1.49,2.969 1.635,2.521 true 1.958,2.958 1.781,2.521 true 0.167,0.333 0.479,0.563 0.313,0.229 12 false *A 1.917,0.75 2.229,0.958 0.313,0.208 12 false *B 0.813,1.792 1.125,1.948 0.313,0.156 10 false *a 0.625,2.354 0.938,2.552 0.313,0.198 10 false M2 2.594,2.344 2.906,2.542 0.313,0.198 10 false E 1.385,3.01 1.698,3.208 0.313,0.198 10 false M1 1.896,3.01 2.427,3.271 0.531,0.26 10 false MRY
*A for LHD
*B for RHD
*a Component without harness connected
(Seat Memory Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (M1) - 1 (E) Memory 1 switch on Below 1 Ω
4 (M2) - 1 (E) Memory 2 switch on Below 1 Ω
2 (MRY) - 1 (E) SET switch on Below 1 Ω


If the result is not as specified, replace the seat memory switch.