Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2016.08
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0104513 NAVIGATION SYSTEM(for SD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  No Sound can be Heard from Speakers  


CAUTION / NOTICE / HINT

HINT:

When the "iPhone" is connected to the USB port of the No. 1 stereo jack adapter, Toyota Link audio may not be output. Before performing troubleshooting, disconnect the "iPhone" connected to the USB port of the No. 1 stereo jack adapter, change the audio output source of the "iPhone" or turn the ignition switch off and then ON again.


PROCEDURE

1.CHECK AUDIO SETTINGS
a.

In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.


HINT:

Sound quality adjustment measures vary according to the type of amplifier.



Result:
Proceed to
OK
NG



OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE