Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) › from 2016.08
RM3090E _58 Vehicle Interior _008788 SEAT BELT _0066374 SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) U

SEAT BELT  SEAT BELT WARNING SYSTEM(w/ Occupant Classification System)  TERMINALS OF ECU  


CHECK COMBINATION METER ASSEMBLY


E161130N05
3.365,0.292 3.771,0.531 0.406,0.24 3.438,0.323 3.719,0.49 0.281,0.167 10 G16

a.

Disconnect the G16 combination meter assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G16-40 (B) - Body ground Y - Body ground Battery power supply Always 11 to 14 V
G16-39 (IG+) - Body ground B - Body ground IG power supply Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
G16-21 (ET) - Body ground BR - Body ground Ground Always Below 1 Ω


c.

Reconnect the G16 combination meter assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G16-14 (RLMT) - Body ground B - Body ground Rear seat belt LH warning light signal Rear seat belt LH fastened Below 1 V
Rear seat belt LH unfastened 11 to 14 V
G16-19 (RCMT) - Body ground P - Body ground Rear seat center belt warning light signal Rear seat center belt fastened Below 1 V
Rear seat center belt unfastened 11 to 14 V
G16-3 (RRMT) - Body ground L - Body ground Rear seat belt RH warning light signal Rear seat belt RH fastened Below 1 V
Rear seat belt RH unfastened 11 to 14 V
G16-24 (RLSB) - Body ground G - Body ground Rear seat belt LH buckle switch signal Rear seat belt LH fastened 11 to 14 V
Rear seat belt LH unfastened Below 1 V
G16-25 (RCSB) - Body ground B - Body ground Rear seat center belt buckle switch signal Rear seat center belt fastened 11 to 14 V
Rear seat center belt unfastened Below 1 V
G16-26 (RRSB) - Body ground W - Body ground Rear seat belt RH buckle switch signal Rear seat belt RH fastened 11 to 14 V
Rear seat belt RH unfastened Below 1 V



CHECK AIRBAG SENSOR ASSEMBLY


C147673N23
3.51,0.094 3.844,0.271 0.333,0.177 1.958,0.094 2.292,0.271 0.333,0.177 5.083,0.094 5.417,0.271 0.333,0.177 3.552,0.094 4.125,0.542 0.573,0.448 10 false G92 2,0.094 2.688,0.542 0.688,0.448 10 false M25 5.125,0.094 5.979,0.656 0.854,0.563 10 false N21

Terminal No. Terminal Symbol Destination
N21-15 LBE+ Front seat inner belt assembly LH
N21-23 LBE- Front seat inner belt assembly LH
M25-9 FSR+ Occupant detection ECU
M25-17 FSR- Occupant detection ECU


CHECK OCCUPANT DETECTION ECU


C238368E08
2.677,0.052 3.021,0.26 0.344,0.208 4.323,0.063 4.667,0.271 0.344,0.208 4.385,0.094 4.844,0.292 0.458,0.198 10 false d16 2.74,0.073 3.198,0.271 0.458,0.198 10 false d15

HINT:

Since the occupant detection ECU uses waterproof connectors, the voltage and waveform cannot be inspected directly. Standard voltage readings and waveforms are indicated for reference only.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specification
d16-1 - d16-3 W - W-B Battery Always 11 to 14 V
d16-2 - d16-3 GR - W-B Diagnosis (DLC3) -* -*
d16-3 - Body ground W-B - Body ground Ground Always Below 1 V
d16-4 - d16-3 LG - W-B Airbag sensor assembly communication line Always Below 1 V
d16-5 - d16-3 P - W-B Front passenger side buckle switch ground line Always Below 1 V
d16-6 - d16-3 B - W-B IG power source Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
d16-7 - d16-4 L - LG Airbag sensor assembly communication line Ignition switch ON Pulse generation
d16-8 - d16-5 G - P Front passenger side buckle switch line Always Pulse generation
d15-1 - d15-5 GR - W Front occupant classification sensor LH power supply line Ignition switch ON 4.9 to 5.1 V
d15-2 - d15-6 V - BR Rear occupant classification sensor LH power supply line Ignition switch ON 4.9 to 5.1 V
d15-3 - d15-5 SB - W Front occupant classification sensor LH signal line Ignition switch ON Pulse generation
d15-4 - d15-6 B - BR Rear occupant classification sensor LH signal line Ignition switch ON Pulse generation
d15-5 - d16-3 W - W-B Front occupant classification sensor LH ground line Always Below 1 Ω
d15-6 - d16-3 BR - W-B Rear occupant classification sensor LH ground line Always Below 1 Ω


*: As this is a line that is connected to other systems, voltage changes according to the systems that are connected.