Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2018.10–2020.01
BM3620E _V1 General _078136 INTRODUCTION _0379061 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO NEGATIVE (-) AUXILIARY BATTERY TERMINAL (for HV Model)


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed

*: When performing learning using the GTS.

Perform steering sensor zero point calibration Lane control system
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system
Panoramic view monitor system (for HV model)
Reset back door close position Power back door system (for HV model)
Power back door initialization Power door lock control system

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.



PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO NEGATIVE (-) AUXILIARY BATTERY TERMINAL (for Gasoline Model)


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed

*: When performing learning using the GTS.

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system
Perform steering sensor zero point calibration Lane control system
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system
Panoramic view monitor system (for Gasoline model)
Reset back door close position Power back door system (for Gasoline model)
Power back door initialization Power door lock control system

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.