Home › Vehicle Exterior › BODY PANEL › FRONT SIDE MEMBER FRONT
BM3620E _01 Vehicle Exterior _077725 BODY PANEL _0383637 FRONT SIDE MEMBER FRONT F

BODY PANEL  FRONT SIDE MEMBER FRONT  ASSEMBLY REPLACEMENT  


K149454

With the radiator side support assembly and fender apron brace cut and join replacement sections removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points

a.

Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)

K148775



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K148776C04
3,3.167 2.833,3.167 2.833,3.167 2.677,2.813 false 1.333,3.896 1.167,3.333 1.167,3.333 1.333,3.333 false 3.052,3.094 3.365,3.25 0.313,0.156 10 false *1 1.406,3.26 1.719,3.417 0.313,0.156 10 false *2
*1 FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY *2 REAR SIDE MEMBER SUB-ASSEMBLY
*a Ultra High Strength Steel Welding Point - -


Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)

When welding 2 panels together including 980 MPa ultra high strength steel.

*a: Plug weld Plug diameter 10 mm (0.39 in.)
Wire type AWS A5.18 ER70S-3
Shield gas Metal active gas

NOTICE:

Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding.Sufficient weld strength cannot be assured when using 100% CO2 shield gas.




b.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


c.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.