Home › Vehicle Exterior › BODY PANEL › COWL TOP SIDE UPPER PANEL
BM3620E _01 Vehicle Exterior _077725 BODY PANEL _0383639 COWL TOP SIDE UPPER PANEL F

BODY PANEL  COWL TOP SIDE UPPER PANEL  ASSEMBLY REPLACEMENT  


K149457

With the cowl top side panel assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points

a.

Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)

K148791



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108825

Plug Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K148792C01
1.667,0.417 1.5,0.417 1.5,0.417 1.781,1.219 false 1.729,0.313 2.042,0.469 0.313,0.156 10 false *1
*1 COWL SIDE REINFORCEMENT SUB-ASSEMBLY - -
*a Ultra High Strength Steel Welding Point - -


Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)

When welding 2 panels together including 780 MPa ultra high strength steel.

*a: Plug weld Plug diameter 10 mm (0.39 in.)
Wire type AWS A5.18 ER70S-3
Shield gas Metal active gas

NOTICE:

Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding.Sufficient weld strength cannot be assured when using 100% CO2 shield gas.




c.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


d.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.