Home › Vehicle Exterior › BODY PANEL › COWL TOP SIDE PANEL
BM3620E _01 Vehicle Exterior _077725 BODY PANEL _0383640 COWL TOP SIDE PANEL F

BODY PANEL  COWL TOP SIDE PANEL  ASSEMBLY REPLACEMENT  


K149456

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108826

Cut with Disc Sander etc.

a.

Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)

K148793



INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108830

Fillet Weld

K148794C01
1.552,1.781 0.667,1 0.667,1 0.5,1 false 0.313,0.917 0.625,1.073 0.313,0.156 10 false *1 3.052,1.292 3.365,1.448 0.313,0.156 10 false *c 3.052,1.802 3.365,1.958 0.313,0.156 10 false *d
*1 SIDE PANEL OUTER NO.2 - -
*a Ultra High Strength Steel Welding Point *b Ultra High Strength Steel Welding Point
*c 15 mm (0.59 in.) *d 11 mm (0.43 in.)


Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)

When welding 2 panels together including 980 MPa ultra high strength steel.

*a: Plug weld Plug diameter 10 mm (0.39 in.)
Wire type AWS A5.18 ER70S-3
Shield gas Metal active gas

NOTICE:

Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding.Sufficient weld strength cannot be assured when using 100% CO2 shield gas.



a.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.