REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
Before removing the outer panel, mark the installation position with tape.
Before removing the outer panel, establish its exact position in relation to the window frame using a reference marker, etc.
| *a | Positioning Tape | *b | Installation Position |
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
|
Adhesive | - | - |
After grinding off the hemming location, remove the outer panel.
| *a | Disc Sander | *b | Hemming Location |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Spot MIG Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).
Do not close the drain hole.
Apply enough adhesive to the panels.
| *a | Drain Hole | - | - |
|
Adhesive | - | - |
Before temporarily installing the new parts, apply body sealer to the reinforcement.
Apply enough adhesive to the panels.
Bend the flange hem with a wooden hammer and dolly.
Bend the panel gradually so as not to distort it.
| *1 | FRONT DOOR PANEL OUTER | - | - |
| *a | Positioning Tape | *b | Cloth Tape |
| *c | Dolly | *d | Wooden Hammer |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.