OPERATION
The combination meter assembly receives the idling on/off signals from the engine stop and start ECU.
The stop and start system settings displayed on the multi-information display can be changed by operating the steering pad switch assembly.
The system operation status or warning information is indicated to the driver through the following means:
Illuminating or flashing the stop and start indicator and stop and start cancel indicator in the combination meter assembly.
Sounding a buzzer.
Displaying other information on the multi-information display.
| *a | Multi-information Display | *b | Stop and Start Indicator |
| *c | Stop and Start Cancel Indicator | - | - |
| *a | Multi-information Display | *b | Stop and Start Indicator |
| *c | Stop and Start Cancel Indicator | - | - |
| Item | Condition | Stop and Start Indicator Light | Buzzer |
|---|---|---|---|
|
*1: Models with CVT *2: Models with manual transaxle *3: The blinking interval is 0.5 seconds. |
|||
| System Operating (Engine is stopped) | The vehicle is operating normally. | Illuminates | Does not sound |
| The driver's door is opened with the shift lever in D.*1 | Blinks*3 | Sounds | |
| The shift lever is operated without depressing the clutch pedal.*2 | |||
| Condition | Stop and Start Cancel Indicator Light |
|---|---|
|
*: The blinking interval is 0.5 seconds. |
|
| The vehicle is stopped and system operation conditions are met. | Does not illuminate |
| When the stop and start cancel switch is on. | Illuminates |
| When any Diagnostic Trouble Code (DTCs) are detected. | Blinks* |
| When the number of times the starter assembly has been operated exceeds the threshold. | |
Multi-information Display Operation
An indicator and/or messages are displayed on the multi-information display to indicate condition of the stop and start system when certain vehicle conditions are met.
| Stop and Start System Condition | Multi-information Display Message*1 | Vehicle Condition | |
|---|---|---|---|
|
*1: Messages are listed in the order of priority. *2: When the engine cannot be stopped by the stop and start system or the engine is restarted while the engine is stopped by the stop and start system, the following mark is displayed on the multi-information display. *3: Models with CVT *4: Models with manual transaxle |
|||
| When the engine cannot be stopped by the stop and start system |
*2 |
"Non-Dedicated Battery" | A non-specified battery for the stop and start system may have been installed. |
| "Battery Charging" | ·
The battery charge amount may be low. ·
A refresh charge may be occurring. |
||
| "Stop & Start System Unavailable" | The engine may have been started with the hood opened. | ||
| "In Preparation" | ·
The vehicle is being driven in a high altitude area. ·
The brake booster vacuum is low. |
||
| "For Climate Control" | ·
The air conditioning system is being used when the ambient temperature is high or low. ·
Windshield defogger is pressed. |
||
| When the engine automatically restarts while stopped by the stop and start system |
*2 |
"In Preparation" | The brake pedal is strongly depressed further or pumped. |
| "For Climate Control" | ·
The air conditioning system is turned on or the air conditioning is being used. ·
Windshield defogger is turned on. |
||
| "Battery Charging" | The battery charge amount may be low. | ||
| Others |
*2 |
"Press Brake More to Activate"*3 | The brake pedal is not depressed enough. |
| - | Stop & Start System Active.
"Shift to N and Press Clutch to Restart"*4 |
The shift lever is moved from N to another position without depressing the clutch pedal. | |
| - | "Stop & Start System Malfunction. Visit Your Dealer" | - | |