Home › Engine / Hybrid System › M20A-FKS (STARTING) › STARTING SYSTEM › 2018.10–2019.09
NM3620E _51 Engine / Hybrid System _076580 M20A-FKS STARTING _0373058 STARTING SYSTEM GE GENERAL F

M20A-FKS STARTING  STARTING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

A planetary type starter assembly is used.


b.

An Inrush Current Reduction (ICR) relay, which is built into the planetary type starter assembly, is used. The ICR relay stabilizes the vehicle power source voltage during starter motor operation.*

*: Models with stop and start system



c.

A tandem solenoid type starter assembly is used. This starter uses a structure in which the flow of current is independently supplied to the motor current solenoid and the solenoid used to push out the pinion gear. Due to this, it is possible to restart the engine when the engine has been stopped but is still moving due to inertia, thereby reducing the amount of time to restart the engine during idling stop control.*

*: Models with stop and start system (with Continuously Variable Transaxle (CVT))



d.

A starter control (cranking hold function) is used. Once the engine switch is pushed, this function operates the starter until the engine starts.*

*: Models with entry and start system




SPECIFICATION


Models without Stop and Start System

*1: Length from the mounted area to the rear end of the starter

*2: Viewed from pinion side

Starter Type Planetary
Rating Output 1.2 kW
Rating Voltage 12 V
Length*1 127.4 mm (5.02 in.)
Weight 2250 g (4.96 lb)
Rotational Direction*2 Clockwise

Models with Stop and Start System

*1: Length from the mounted area to the rear end of the starter

*2: Viewed from pinion side

Starter Type Planetary (built-in ICR Relay) Planetary (built-in ICR Relay) with Tandem Solenoid
Rating Output 1.7 kW 1.7 kW
Rating Voltage 12 V 12 V
Length*1 159.0 mm (6.26 in.) 159.0 mm (6.26 in.)
Weight 3850 g (8.5 lb) 4000 g (8.8 lb)
Rotational Direction*2 Clockwise Clockwise