FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
|
*1: HV models *2: Gasoline models *3: Models with manual transaxle |
|
| Television Camera Assembly | Sends a video signal of the area behind the vehicle to the radio and display receiver assembly. |
| Radio and Display Receiver Assembly | ·
Receives signals from the hybrid vehicle control ECU*1, ECM*2 or back-up light switch assembly*3 and turns the television camera assembly on and off. ·
Displays the image transmitted by the television camera assembly on the screen. |
| Hybrid Vehicle Control ECU*1 | Sends an R shift position signal to the radio and display receiver assembly. |
| ECM*2 | |
| Back-up Light Switch Assembly*3 | |
SYSTEM CONTROL
This system operates when both the following conditions have been met:
Power switch is turned on (IG). (HV models)
Ignition switch is turned ON. (Gasoline models)
The shift position is R.
Area Displayed on Screen
Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.
The television camera assembly uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the television camera assembly is limited. The television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.
FAIL-SAFE
The table below indicates fail-safe operation when a malfunction is detected:
| Malfunctioning Part | Detection Item | Function |
|---|---|---|
| Television Camera Assembly | Television Camera Assembly malfunction signal is detected. | System stops signal reception and displays a dark screen. |