Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for HV Model)
NM3620E _58 Vehicle Interior _077397 THEFT DETERRENT / KEYLESS ENTRY _0376109 ENTRY AND START SYSTEM(for HV Model) DE DETAILS F

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for HV Model)  DETAILS  DOOR CONTROL RECEIVER  


CONSTRUCTION


a.

The electrical key and door control receiver can operate on 2 different RF channels. When an electrical key is brought within an exterior detection area, key verification begins. If key verification fails due to radio wave interference, the channel will be switched and key verification will be performed again. The multi-channel system begins verification using the channel on which the last verification was successfully performed. When verification fails, the system switches to the other channel.

Y112026E20
2.365,1.25 2.521,1.406 0.156,0.156 10 false *a 0.073,0.802 0.958,1.188 0.885,0.385 10 false LF Band (from Vehicle) 0.042,2.385 0.969,3.417 0.927,1.031 10 false RF Band (from Electrical Key) 3.427,1.26 3.583,1.417 0.156,0.156 10 false *b 3.698,1.26 3.854,1.417 0.156,0.156 10 false *c 4.708,1.25 4.865,1.406 0.156,0.156 10 false *d 4.969,1.25 5.125,1.406 0.156,0.156 10 false *e 6,1.25 6.146,1.406 0.146,0.156 10 false *f 3.01,1.844 3.229,2.042 0.219,0.198 10 false *g 4.313,1.854 4.49,2.042 0.177,0.188 10 false *g 5.594,1.854 5.813,2.115 0.219,0.26 10 false *g

*a Exterior detection areas are created using LF waves (emitted from the vehicle at intervals of 0.25 seconds) to receive a response from the electrical key.
*b When the electrical key is brought into an exterior detection area, it receives LF waves from the vehicle. Using RF waves, the electrical key responds to the vehicle.
*c Upon receiving the response from the electrical key, the certification ECU activates the electrical key antennas (outside) one by one. Using LF waves, the certification ECU determines which exterior detection area the electrical key is in.
*d The electrical key receives the LF waves from the vehicle and responds using RF waves. (The certification ECU recognizes which exterior detection area the electrical key is in.)
*e The certification ECU sends registered key ID information to the electrical key using LF waves. (Up to 7 key IDs can be registered.)
*f The electrical key sends the key ID information using RF waves. When the certification ECU receives it, verification completes.
*g Radio wave interference (channel switching)


b.

The multi-channel system changes channels when communication on the RF band (*b, *d and *f) is interrupted by radio wave interference. Refer to the table below to confirm when the system changes channels:

*b or *d is NG *f is NG
Condition RF waves cannot be received RF waves cannot be received properly RF waves cannot be received RF waves cannot be received properly
Channel switching Channels will not be switched. Channels will be switched. Channels will be switched.* Channels will be switched.

HINT:

*: Channel switching does not occur during vehicle interior certification after vehicle exterior certification completes for the entry lock operation.