Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM
NM3620E _59 Vehicle Exterior _077728 EXTERIOR PANELS / TRIM _0377328 GRILLE SHUTTER SYSTEM CO CONTROL F

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM  CONTROL  GRILLE SHUTTER CONTROL  


FUNCTION OF MAIN COMPONENTS


Item Function

*1: HV models

*2: Gasoline models

Swing Grille Actuator Assembly
·

Actuates the radiator shutter sub-assembly based on the signal from the air conditioning amplifier assembly, hybrid vehicle control ECU*1 and ECM.

·

Sends a diagnosis signal to the combination meter assembly when a malfunction is detected.


Radiator Shutter Sub-assembly The fins of the radiator shutter sub-assembly are closed by the swing grille actuator assembly to block the airflow to the engine compartment.
Hybrid Vehicle Control ECU*1 Sends a vehicle speed signal and inverter coolant temperature to the swing grille actuator assembly via CAN communication.
ECM Sends an engine coolant temperature signal to the swing grille actuator assembly via CAN communication.
Air Conditioning Amplifier Assembly Sends the A/C refrigerant pressure and outside temperature to the swing grille actuator assembly via CAN communication.
Main Body ECU (Multiplex Network Body ECU) Sends an power switch*1 or ignition switch*2 signal to the swing grille actuator assembly via CAN communication.
Combination Meter Assembly Displays a message on the multi-information display to alert the driver with a signal provided by the swing grille actuator assembly.


OPERATION


a.

The swing grille actuator assembly performs cold condition control while the engine coolant temperature and hybrid inverter coolant temperature* is low.

HINT:

*: HV models



b.

The swing grille actuator assembly performs high speed traveling control.

Item Description
Cold Condition Control
·

When the power switch*1 or ignition switch*2 is ON at the engine coolant temperature is below 40°C (104°F) , the grille shutter is closed until the engine coolant temperature reaches 75°C (167°F).

·

Using the air conditioner with low outside temperature, the grille shutter is opened when the pressure of the refrigerant becomes higher.


High Speed Traveling Control
·

When the vehicle traveling speed is between approximately 60 to 150 km/h (37 to 93 mph), the grille shutter is closed.

·

When the vehicle is traveling and engine coolant temperature is approximately 97°C (207°F) or more, the grille shutter is opened.

·

When the vehicle is traveling and outside temperature is approximately 35°C (95°F) or more, the grille shutter is opened.

·

When the vehicle is traveling and air conditioning refrigerant pressure is high, the grille shutter opens and closes in accordance with the vehicle speed and the outside air temperature, etc.


Winter Control Mode
·

Stops the grille shutter at a position other than the fully closed position and suspends grille shutter operation in order to prevent it from becoming stuck closed when the ambient temperature is 5°C (41°F) or lower.

·

Winter control mode is canceled when the ambient temperature becomes 10°C (50°F) or higher.



HINT:

Sometimes, the grille shutter operates after the power switch*1 or ignition switch*2 turned to ON or Off. This does not indicate a malfunction.

*1: HV models

*2: Gasoline models




FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display and buzzer to provide the driver with grille shutter system malfunction information.


ii.

When the system is not available, the following warning occurs to warn the driver.

When a system malfunction is detected
Multi-information Display Detail Buzzer DTC
Grille Shutter
Malfunction
Visit Your Dealer
This message appears when the swing grille actuator assembly detects a system malfunction Sounds once Repair is required DTCs are stored

HINT:

The maintenance mode can be cancel using the Global TechStream (GTS) or driving the vehicle. For details, refer to the Repair Manual.





DIAGNOSIS


a.

If the air conditioning amplifier assembly detects a malfunction in the grille shutter system, Diagnostic Trouble Codes (DTCs) are stored in the air conditioning amplifier assembly.

i.

The 5-digit DTCs can be read by connecting the Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.