The occupant detection ECU receives signals from the skid control ECU assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1798 | Yaw Rate Sensor Module Malfunction | Acceleration signals are abnormal | ·
Airbag Sensor Assembly ·
CAN communication system ·
Occupant detection ECU |
| B1799 | Vehicle Stability Control ECU Malfunction | Vehicle speed signal from brake actuator assembly (skid control ECU) is abnormal | ·
Electronically controlled brake system ·
CAN communication system ·
Occupant detection ECU |
When DTC B1650 is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1798 or B1799 is output, perform troubleshooting for this DTC first.
If it is difficult to perform troubleshooting (wire harness inspection), remove the front passenger seat installation bolts to see under the seat cushion.
In the above case, lift and hold the seat so that it does not fall down. Hold the seat only as necessary because holding the seat for a long period of time may cause seat rail deformation.
Check for electronically controlled brake system DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, check if the CAN communication system is functioning normally.
Refer to CAN Bus Check in CAN Communication System.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
CAN communication system is functioning normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: System Select / Health Check.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG