Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM
RM3620E _58 Vehicle Interior _076039 PRE-COLLISION _0369995 PRE-COLLISION SYSTEM U

PRE-COLLISION  PRE-COLLISION SYSTEM  TERMINALS OF ECU  


CHECK FORWARD RECOGNITION CAMERA


NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply larger loads than necessary since the connector may be damaged.


E402277N02
2.083,0.823 2.427,1.063 0.344,0.24 2.156,0.865 2.479,1.073 0.323,0.208 10 false P8


a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
P8-7 (IGB) - P8-10 (GND) LA-P - W-B Power source Ignition switch ON 11 to 14 V*1, *2
10.5 to 16 V*3
Ignition switch off Below 1 V
P8-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

*1: w/o Stop and Start System

*2: w/ Stop and Start System (except Manual Transaxle)

*3: w/ Stop and Start System (for Manual Transaxle)




CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>TERMINALS OF ECU