Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM
RM3620E _58 Vehicle Interior _076039 PRE-COLLISION _0369995 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  DIAGNOSIS SYSTEM  


FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

Master Warning Indicator Warning Message Detail DTC/RoB PCS warning light
Illuminated "Pre-Collision System Malfunction Visit Your Dealer" is displayed Pre-collision system malfunctioning Stored Illuminates
Not illuminated "Pre-Collision System Unavailable" is displayed Millimeter wave radar sensor assembly misaligned Stored Illuminates
Not illuminated "Pre-Collision System Unavailable" is displayed
·

Millimeter wave radar sensor assembly temperature malfunction

·

Millimeter wave radar sensor assembly voltage malfunction


Stored Illuminates
Not illuminated "Pre-Collision System Unavailable Clean Sensor" is displayed Foreign matter attached to millimeter wave radar sensor assembly Stored Illuminates
Not illuminated "Front Camera Unavailable" is displayed
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range

·

Other forward recognition camera malfunction


Stored Illuminates
Not illuminated "Front Camera Unavailable See Owner's Manual" is displayed
·

Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera

·

Forward recognition camera or area of windshield in front of forward recognition camera is fogged up


Stored Illuminates
Not illuminated "VSC Turned Off Pre-Collision Brake System Unavailable" is displayed Electronically controlled brake system disabled Not stored Illuminates

HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Illuminates
·

Pre-collision system malfunctioning

·

Pre-collision system temporarily disabled

·

Pre-collision system disabled

·

Electronically controlled brake system disabled


Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the ignition switch is off for more than 2 seconds and then turned ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will illuminate and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.



CONSTANT CHECK


a.

The forward recognition camera constantly monitors the pre-collision system for malfunctions after the ignition switch is turned to ON and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.