| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | While the vehicle is being driven at 5 km/h (3 mph) or more, a communication error between the ECM and the forward recognition camera is detected for approximately 6 seconds or more. | CAN communication system |
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | While the vehicle is being driven at 5 km/h (3 mph) or more, a communication error between the airbag sensor assembly and the forward recognition camera is detected for approximately 4 seconds or more. | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | for HV Model:
3 seconds after the ignition switch is turned to ON, a communication error between the brake booster with master cylinder assembly (skid control ECU) and the forward recognition camera is detected for approximately 1 second or more. for Gasoline Model:
3 seconds after the ignition switch is turned to ON, a communication error between the brake actuator assembly (skid control ECU) and the forward recognition camera is detected for approximately 1 second or more. |
CAN communication system |
| U029387 | Lost Communication with Hybrid Powertrain Control Module Missing Message | While the vehicle is being driven at 5 km/h (3 mph) or more, a communication error between the hybrid vehicle control ECU and the forward recognition camera is detected for approximately 6 seconds or more. | CAN communication system |
Clear the DTCs.
Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Recheck for DTCs and check that no DTCs are output.
Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR
U010087, U012587, U012687, U012987 and U029387 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
for HV Model:
for Gasoline Model: