Home › Drivetrain › CLUTCH › CLUTCH UNIT
RM3620E _52 Drivetrain _076045 CLUTCH _0370087 CLUTCH UNIT G

CLUTCH  CLUTCH UNIT  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C403599

a.

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If necessary, replace the clutch disc assembly.


b.

Install the clutch disc assembly onto the manual transaxle assembly.

HINT:

Insert the clutch disc assembly in the correct direction.



c.
C403600

Using a dial gauge, measure the clutch disc assembly runout.

Maximum runout:

0.8 mm (0.0314 in.)


If necessary, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C403601N01
0.313,0.563 0.469,0.76 0.156,0.198 10 false A 1,0.333 1.156,0.531 0.156,0.198 10 false B

a.

Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Maximum depth A:

0.5 mm (0.0196 in.)


Maximum width B:

6.0 mm (0.236 in.)


If necessary, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

C403602

a.

Using a dial gauge, check the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00393 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.