88280A
1.INSPECT CLUTCH START SWITCH ASSEMBLY
| *a | Component without harness connected
(Clutch Start Switch Assembly) |
| *b | 11.35 to 12.35 mm (0.447 to 0.486 in.) |
| *c | ON |
| *d | OFF |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | On (pushed) | Below 1 Ω |
| 1 - 2 | Off (not pushed) | 10 kΩ or higher |
If the result is not as specified, replace the clutch start switch assembly.