If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 2 speaker assembly | A |
| Rear speaker assembly | B |
If sound cannot be heard from any speaker, inspect all of them.
A
B
Disconnect the G4 radio and display receiver assembly connector.
Disconnect the I1 and J1 front No. 1 speaker assembly connectors.
Disconnect the G5 and G6 front No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G4-1 (FR+) - G5-4 (TWR+) | Always | Below 1 Ω |
| G4-6 (FR-) - G5-2 (TWR-) | Always | Below 1 Ω |
| G4-2 (FL+) - G6-4 (TWL+) | Always | Below 1 Ω |
| G4-7 (FL-) - G6-2 (TWL-) | Always | Below 1 Ω |
| I1-2 (+) - G5-3 (+) | Always | Below 1 Ω |
| I1-1 (-) - G5-1 (-) | Always | Below 1 Ω |
| J1-2 (+) - G6-3 (+) | Always | Below 1 Ω |
| J1-1 (-) - G6-1 (-) | Always | Below 1 Ω |
| G4-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| G4-6 (FR-) - Body ground | Always | 10 kΩ or higher |
| G4-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| G4-7 (FL-) - Body ground | Always | 10 kΩ or higher |
| G5-3 (+) - Body ground | Always | 10 kΩ or higher |
| G5-1 (-) - Body ground | Always | 10 kΩ or higher |
| G6-3 (+) - Body ground | Always | 10 kΩ or higher |
| G6-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Check the malfunction disappears.
Malfunction disappears.
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both the LH and RH sides.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
Disconnect the G4 radio and display receiver assembly connector.
Disconnect the K1 and L1 rear speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G4-4 (RR+) - K1-2 (+) | Always | Below 1 Ω |
| G4-9 (RR-) - K1-1 (-) | Always | Below 1 Ω |
| G4-3 (RL+) - L1-2 (+) | Always | Below 1 Ω |
| G4-8 (RL-) - L1-1 (-) | Always | Below 1 Ω |
| G4-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| G4-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| G4-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| G4-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 3 speaker assembly | A |
| Front No. 2 speaker assembly | B |
| Rear speaker assembly | C |
| Rear No. 2 speaker assembly | D |
If sound cannot be heard from any speaker, inspect all of them.
A
B
C
D
Disconnect the M2 stereo component amplifier assembly connector.
Disconnect the J1 and I1 front No. 1 speaker assembly connectors.
Disconnect the G6 and G5 front No. 3 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-9 (FR+) - G5-4 (TWR+) | Always | Below 1 Ω |
| M2-24 (FR-) - G5-2 (TWR-) | Always | Below 1 Ω |
| M2-14 (FL+) - G6-4 (TWL+) | Always | Below 1 Ω |
| M2-29 (FL-) - G6-2 (TWL-) | Always | Below 1 Ω |
| J1-2 (+) - G6-3 (+) | Always | Below 1 Ω |
| J1-1 (-) - G6-1 (-) | Always | Below 1 Ω |
| I1-2 (+) - G5-3 (+) | Always | Below 1 Ω |
| I1-1 (-) - G5-1 (-) | Always | Below 1 Ω |
| M2-9 (FR+) - Body ground | Always | 10 kΩ or higher |
| M2-24 (FR-) - Body ground | Always | 10 kΩ or higher |
| M2-14 (FL+) - Body ground | Always | 10 kΩ or higher |
| M2-29 (FL-) - Body ground | Always | 10 kΩ or higher |
| G6-3 (+) - Body ground | Always | 10 kΩ or higher |
| G6-1 (-) - Body ground | Always | 10 kΩ or higher |
| G5-3 (+) - Body ground | Always | 10 kΩ or higher |
| G5-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>REMOVAL
Inspect the front No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the M2 stereo component amplifier assembly connector.
Disconnect the G8 and G7 front No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-10 (TWL+) - G8-1 (+) | Always | Below 1 Ω |
| M2-25 (TWL-) - G8-2 (-) | Always | Below 1 Ω |
| M2-13 (TWR+) - G7-1 (+) | Always | Below 1 Ω |
| M2-28 (TWR-) - G7-2 (-) | Always | Below 1 Ω |
| M2-10 (TWL+) - Body ground | Always | 10 kΩ or higher |
| M2-25 (TWL-) - Body ground | Always | 10 kΩ or higher |
| M2-13 (TWR+) - Body ground | Always | 10 kΩ or higher |
| M2-28 (TWR-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the M2 stereo component amplifier assembly connector.
Disconnect the L1 and K1 rear speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-12 (RR+) - K1-2 (+) | Always | Below 1 Ω |
| M2-27 (RR-) - K1-1 (-) | Always | Below 1 Ω |
| M2-11 (RL+) - L1-2 (+) | Always | Below 1 Ω |
| M2-26 (RL-) - L1-1 (-) | Always | Below 1 Ω |
| M2-12 (RR+) - Body ground | Always | 10 kΩ or higher |
| M2-27 (RR-) - Body ground | Always | 10 kΩ or higher |
| M2-11 (RL+) - Body ground | Always | 10 kΩ or higher |
| M2-26 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the M2 stereo component amplifier assembly connector.
Disconnect the N1 rear No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-15 (WFR+) - N1-4 (WF+) | Always | Below 1 Ω |
| M2-30 (WFR-) - N1-1 (WF-) | Always | Below 1 Ω |
| M2-8 (WFL+) - N1-2 (WF+) | Always | Below 1 Ω |
| M2-23 (WFL-) - N1-3 (WF-) | Always | Below 1 Ω |
| M2-15 (WFR+) - Body ground | Always | 10 kΩ or higher |
| M2-30 (WFR-) - Body ground | Always | 10 kΩ or higher |
| M2-8 (WFL+) - Body ground | Always | 10 kΩ or higher |
| M2-23 (WFL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>REMOVAL
Inspect the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG