Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81340
1.REMOVE VANITY LIGHT ASSEMBLY
|
Remove in this Direction |
Using moulding remover A, insert it between the vanity light assembly and roof headlining assembly to detach the claw as shown in the illustration.
|
Remove in this Direction |
Pull out the vanity light assembly to detach the guide as shown in the illustration.
Detach the claw and remove the vanity light assembly from the vanity light bulb holder.
81340B
2.REMOVE VANITY LIGHT BULB
|
Remove in this Direction |
Remove the vanity light bulb as shown in the illustration.