Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81340
1.REMOVE VANITY LIGHT ASSEMBLY
|
Remove in this Direction |
Using moulding remover A, insert it between the vanity light assembly and roof headlining assembly to detach the claw as shown in the illustration.
|
Remove in this Direction |
Pull out the vanity light assembly and detach the guide as shown in the illustration.
81340B
2.REMOVE VANITY LIGHT BULB
|
Remove in this Direction |
Remove the vanity light bulb from the vanity light bulb holder as shown in the illustration.
81340B
3.INSTALL VANITY LIGHT BULB
|
Install in this Direction |
Install the vanity light bulb to the vanity light bulb holder as shown in the illustration.
81340
4.INSTALL VANITY LIGHT ASSEMBLY
|
Install in this Direction |
Attach the guide to set the vanity light assembly to the roof headlining assembly as shown in the illustration.
|
Install in this Direction |
Lift up the vanity light assembly upward to attach the claw to install it as shown in the illustration.