Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
81340
1.REMOVE VANITY LIGHT ASSEMBLY
Use the same procedure for both vanity light assemblies.
| *1 | Bulb Holder |
| *a | Claw A |
| *b | Claw B |
Detach claw A and detach the bulb holder from the vanity light assembly.
Detach claw B and remove the vanity light assembly.
63341
2.REMOVE NO. 1 ROOF SILENCER PAD (for Normal Roof)
Remove the 6 No. 1 roof silencer pads.
63352C
3.REMOVE ROOF HEADLINING PAD END (for Normal Roof)
Remove the 2 roof headlining pad ends.
63354C
4.REMOVE ROOF HEADLINING FRONT SIDE PAD (for Normal Roof, for Cold Area)
Remove the 2 roof headlining front side pads.
63351B
5.REMOVE ROOF HEADLINING PAD (for Normal Roof, for Cold Area)
Remove the 2 roof headlining pads.
63352D
6.REMOVE NO. 2 ROOF HEADLINING PAD (for Normal Roof, for Cold Area)
Remove the No. 2 roof headlining pad.
63341
7.REMOVE NO. 1 ROOF SILENCER PAD (for Moon Roof)
Remove the 2 No. 1 roof silencer pads.
63352C
8.REMOVE ROOF HEADLINING PAD END (for Moon Roof)
Remove the 2 roof headlining pad ends.
63356B
9.REMOVE ROOF HEADLINING PAD LH (for Moon Roof, for Korea)
Remove the roof headlining pad LH.
63355C
10.REMOVE ROOF HEADLINING PAD RH (for Moon Roof, for Korea)
Remove the roof headlining pad RH.
63362
11.REMOVE NO. 2 ROOF HEADLINING SUPPORT (for Moon Roof, for Korea)
Remove the No. 2 roof headlining support.
63361
12.REMOVE NO. 1 ROOF HEADLINING SUPPORT (for Moon Roof, for Korea)
Remove the No. 1 roof headlining support.
63364
13.REMOVE NO. 4 ROOF HEADLINING SUPPORT (for Moon Roof, for Korea)
Remove the No. 4 roof headlining support.
63363
14.REMOVE NO. 3 ROOF HEADLINING SUPPORT (for Moon Roof, for Korea)
Remove the No. 3 roof headlining support.
63354C
15.REMOVE ROOF HEADLINING FRONT SIDE PAD (for Moon Roof, for Cold Area)
Remove the 2 roof headlining front side pads.
63352C
16.REMOVE ROOF HEADLINING PAD END (for Panoramic Moon Roof)
Remove the 2 roof headlining pad ends.
63354C
17.REMOVE ROOF HEADLINING FRONT SIDE PAD (for Panoramic Moon Roof, for Cold Area)
Remove the 2 roof headlining front side pads.
82171
18.REMOVE NO. 1 ROOF WIRE (for LHD)
for Normal Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor or w/ Humidity Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
for Moon Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor or w/ Humidity Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
for Panoramic Moon Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor or w/ Humidity Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
82171
19.REMOVE NO. 1 ROOF WIRE (for RHD)
for Normal Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor or w/ Humidity Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
for Moon Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
for Panoramic Moon Roof:
|
Remove in this Direction |
Turn the visor connectors approximately 90° counterclockwise and remove them from the roof headlining.
Remove each piece of tape and the No. 1 roof wire from the roof headlining.
| *A | w/ EC Mirror | *B | w/ Digital Inner Mirror |
| *C | w/o Pre-collision System | *D | w/ Pre-collision System |
| *E | w/ Rain Sensor or w/ Humidity Sensor | - | - |
| *1 | No. 1 Roof Wire | - | - |
|
Tape | - | - |
Remove the butyl tape remaining on the roof headlining.
86101D
20.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
64714J
21.REMOVE DECK SIDE TRIM COVER RH
Detach the claw and remove the deck side trim cover RH.