The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store the DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P160700 | Cruise Control Input Processor | When prohibited by the sub-CPU, the cruise control system operates for 0.3 seconds or more. | ECM |
Before replacing the ECM refer to Service Bulletin.
The ECM receives signals from each sensor to control all functions of the cruise control system. When a DTC is detected, the fail-safe function remains on until the ignition switch off.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for Gasoline Model)>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for Gasoline Model)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P160700 is not output | A |
| DTC P160700 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for A25A-FKS:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ECM>REMOVAL
for M20A-FKS:
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ECM>REMOVAL