Home › Engine / Hybrid System › CRUISE CONTROL › SPEED LIMITER SYSTEM (for Gasoline Model)
RM3620E _51 Engine / Hybrid System _076038 CRUISE CONTROL _0370337 SPEED LIMITER SYSTEM(for Gasoline Model) C

CRUISE CONTROL  SPEED LIMITER SYSTEM(for Gasoline Model)  U012200  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

The ECM communicates with each sensor and ECU via CAN communication.

If there are any malfunctions in the communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U012200 Lost Communication with Vehicle Dynamics Control Module While speed limiter is operating, communication stop between skid control ECU (brake actuator assembly) and ECM is detected.
·

CAN communication circuit

·

Skid control ECU (brake actuator assembly)

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

When this DTC is stored, speed limiter system operation will be prohibited. Even after DTCs are cleared, operation of the speed limiter system will remain prohibited until the following is performed.

·

Turn the ignition switch from off to ON, drive the vehicle at a speed of 15 km/h (9 mph) or more for at least 10 seconds, then turn the speed limiter system on.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM (FOR GASOLINE MODEL)
a.

Using the GTS, check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication is normal A
CAN communication is malfunctioning B



A

B