Use the following procedure to troubleshoot the speed limiter system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
A
B
Refer to DTC Check / Clear.
Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM (for HV Model)>DTC CHECK / CLEAR
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
| Result | Proceed to |
|---|---|
| DTC does not reoccur | A |
| DTC reoccurs | B |
A
B
Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM (for HV Model)>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Operation Check
Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM (for HV Model)>OPERATION CHECK
Terminals of ECU
Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM (for HV Model)>TERMINALS OF ECU
Data List / Active Test
Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM (for HV Model)>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT