Home › Drivetrain › UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM3620E _52 Drivetrain _076122 UB80E AUTOMATIC TRANSMISSION / TRANSAXLE _0370669 PARK / NEUTRAL POSITION SWITCH A

UB80E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.

NOTICE:

Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.



b.

Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.


c.
C402665C01
0.5,1.667 0.667,1.833 0.167,0.167 10 true *a 1.708,2 1.875,2.167 0.167,0.167 10 true *b
*a P
*b N


Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


d.

Remove the transmission control shaft lever from the park/neutral position switch assembly.


e.
C402664C01
0.917,1.5 1.083,1.5 1.083,1.5 1.615,0.865 true 2.083,1.75 1.865,1.75 1.865,1.75 1.865,1.031 true 2.115,1.667 2.281,1.833 0.167,0.167 10 true *a 0.708,1.417 0.875,1.583 0.167,0.167 10 true *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


f.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


g.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


h.

Connect the park/neutral position switch assembly connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C402666C01
0.583,2 0.75,2.167 0.167,0.167 10 false *a 2.25,2 2.417,2.167 0.167,0.167 10 false *b
*a Correct
*b Incorrect


Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.

NOTICE:

Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.



Hide 74404B 3.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 84540 6.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION