CHECK FORWARD RECOGNITION CAMERA
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| P8-7 (IGB) - Body ground | LA-P - Body ground | Power source | Ignition switch ON | 10.5 to 16 V*1
11 to 14 V*2 |
| Ignition switch off | Below 1 V | |||
| P8-3 (LKSW) - P8-10 (GND) | R - W-B | Steering pad switch signal | Ignition switch off, LTA/LDA main switch off | 1 MΩ or higher |
| Ignition switch off, LTA/LDA main switch on | 228 to 252 Ω | |||
| P8-10 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
*1: w/ Stop and Start System (for Manual Transaxle)
*2: w/ Stop and Start System (except Manual Transaxle), w/o Stop and Start System