Home › Engine / Hybrid System › CRUISE CONTROL › LANE CONTROL SYSTEM
RM3620E _51 Engine / Hybrid System _076038 CRUISE CONTROL _0370841 LANE CONTROL SYSTEM U

CRUISE CONTROL  LANE CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Control / Data List.


e.

Read the Data List according to the display on the GTS.

Chassis > Lane Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled Total distance traveled 0 to 16777215 - Not used
Total Distance Traveled - Unit Unit used for total distance traveled km or mile - Not used
LDA Control Whether lane control system is permitted or not Prohibit or Permit Prohibited: Lane control system control is not possible
Permitted: Lane control system control is possible
-
Turn Switch (Right) Turn signal switch (right) status OFF or ON ON: Turn signal light switch on (right)
OFF: Turn signal light switch off
-
Turn Switch (Left) Turn signal switch (left) status OFF or ON ON: Turn signal light switch on (left)
OFF: Turn signal light switch off
-
Vehicle Information (2WD/4WD) Vehicle information (drivetrain) stored in forward recognition camera 2WD, 4WD or Unknown - Not used
Vehicle Information (Conv/HV) Vehicle information (conventional/hybrid) stored in forward recognition camera Conv, HV or Unknown - Not used


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Control / Active Test.


e.

Perform Active Test according to the display on the GTS.

HINT:

The ignition switch must be turned to ON to proceed with the Active Test using the GTS.


Chassis > Lane Control > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Buzzer Sounds the LTA buzzer (meter buzzer) Start/Stop Confirm that the vehicle is stopped with the ignition switch to ON.

f.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


g.

Perform Active Test according to the display on the GTS.

HINT:

The ignition switch must be turned to ON to proceed with the Active Test using the GTS.


Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display (All) Multi-information display ON Confirm that the vehicle is stopped with the ignition switch to ON.