CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Disconnect the G2 and G3 radio and display receiver assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
|
*1: w/o Stop and Start System *2: w/ Stop and Start System |
||||
| G2-19 (IG) - Body ground | W - Body ground | Power source of IG | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| G3-15 (ACC1) - Body ground | GR - Body ground | Power source of ACC | Ignition switch off | Below 1 V |
| Ignition switch ACC | 11 to 14 V*1
10.5 to 16 V*2 |
|||
| G3-4 (+B1) - Body ground | LG - Body ground*1
BE - Body ground*2 |
Battery | Ignition switch off | 11 to 14 V*1
10.5 to 16 V*2 |
| G3-1 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the G2 and G3 radio and display receiver assembly connectors.
Measure the voltage and check for waveform according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G3-28 (REV) - Body ground | W - Body ground | Reverse signal | Ignition switch ON, shift lever in R | 11 to 14 V |
| Ignition switch ON, shift lever not in R | Below 1 V | |||
| G2-28 (V+) - G2-29 (V-) | B - W | Display signal | Ignition switch ON, shift lever in R | Pulse generation (See waveform 1) |
| Ignition switch ON, shift lever in R, screen blacked out by covering camera lens | Pulse generation (See waveform 2) | |||
| G2-30 (CA+) - G2-27 (CGND) | R - G | Power source | Ignition switch ACC | 5.5 to 7.05 V |
| G2-27 (CGND) - Body ground | G - Body ground | Camera ground | Always | Below 1 Ω |
| G2-26 (CSLD) - Body ground | Shielded - Body ground | Shield ground | Always | Below 1 Ω |
Using an oscilloscope, check waveform 1.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | G2-28 (V+) - G2-29 (V-) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Ignition switch ON, shift lever in R |
Using an oscilloscope, check waveform 2.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | G2-28 (V+) - G2-29 (V-) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Ignition switch ON, shift lever in R, screen blacked out by covering camera lens |