Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM3620E _56 Audio / Visual / Telematics _076129 PARK ASSIST / MONITORING _0370833 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  U0293  Lost Communication with Hybrid Control Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.


Blind Spot Monitor Master
DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" Lost communication with ECM*1 CAN communication system
U0125 Lost Communication with Yaw Rate Sensor Module Lost communication with yaw rate sensor CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with skid control ECU assembly CAN communication system
U0142 Lost Communication with Body Control Module "B" Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0293 Lost Communication with Hybrid Control Module Lost communication with hybrid vehicle control ECU assembly*2 CAN communication system

Blind Spot Monitor Slave
DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" Lost communication with ECM*1 CAN communication system
U0125 Lost Communication with Yaw Rate Sensor Module Lost communication with yaw rate sensor CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with skid control ECU assembly CAN communication system
U0142 Lost Communication with Body Control Module "B" Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0293 Lost Communication with Hybrid Control Module Lost communication with hybrid vehicle control ECU assembly*2 CAN communication system

*1: for Gasoline Model

*2: for HV Model


CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


c.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314
Result:
Result Proceed to
Blind Spot Monitor Master DTCs including DTC U0232 are output. A
Blind Spot Monitor Master DTCs other than DTC U0232 are output. B
No DTCs are output C



HINT:
·

If CAN communication system DTCs are stored, they may also be stored for other systems.

·

If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even if the DTCs were not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

B

C