Home › Power Source / Network › A25A-FKS (BATTERY / CHARGING) › CHARGING SYSTEM
RM3620E _57 Power Source / Network _076183 A25A-FKS BATTERY / CHARGING _0371282 CHARGING SYSTEM L

A25A-FKS BATTERY / CHARGING  CHARGING SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:

Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the charging system have been removed/installed or replaced, or the cable has been disconnected from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


HINT:

w/ Stop And Start System:

After charging the battery, perform the integrated current value initialization.

Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM (for A25A-FKS)>REGISTRATION




CHARGING SYSTEM PRECAUTION



NOTICE:
·

Check that the battery cables are connected to the correct terminals.

·

Disconnect the battery cables when the battery is given a quick charge.

·

Do not perform tests with a high voltage insulation resistance tester.

·

Never disconnect the battery cables while the engine is running.

·

Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the No. 1 engine room relay block.