Home › Power Source / Network › A25A-FKS (BATTERY / CHARGING) › CHARGING SYSTEM › 2018.10–2020.08
RM3620E _57 Power Source / Network _076183 A25A-FKS BATTERY / CHARGING _0371282 CHARGING SYSTEM C

A25A-FKS BATTERY / CHARGING  CHARGING SYSTEM  P16027B  Deterioration of Battery Low Fluid Level  


DESCRIPTION

The ECM determines the battery status according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P16027B Deterioration of Battery Low Fluid Level Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning light does not come on DTC stored SAE Code: P1602

WIRING DIAGRAM

A427638E05
5.333,0.813 5.948,1.01 0.615,0.198 10 false BATT 5.365,2.323 5.677,2.521 0.313,0.198 10 false E1 5.833,2.969 6.292,3.167 0.458,0.198 10 false A24 5.833,3.135 6.292,3.333 0.458,0.198 10 false ECM 5.042,2.219 5.354,2.417 0.313,0.198 10 false 10 5.083,0.823 5.24,1.021 0.156,0.198 10 false 1 2.792,1.083 4.021,1.281 1.229,0.198 10 false EFI-MAIN NO.4 0.563,0.927 2.396,1.125 1.833,0.198 10 false from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

If any DTCs other than P16027B are output, troubleshoot those DTCs first.


PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the A24 ECM connector.


b.
A402428C02
0.198,0.917 0.583,1.146 0.385,0.229 0.771,1.813 1.25,0.865 true 0.219,0.25 0.531,0.448 0.313,0.198 10 false *a 0.594,1.865 1.094,2.115 0.5,0.25 10 false BATT 0.271,0.958 0.583,1.156 0.313,0.198 10 false A24
*a Front view of wire harness connector
(to ECM)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A24-1 (BATT) - Body ground Always 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR