Home › Power Source / Network › A25A-FKS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR
RM3620E _57 Power Source / Network _076183 A25A-FKS BATTERY / CHARGING _0371286 BATTERY CURRENT SENSOR A

A25A-FKS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Attach the 2 claws and install the battery state sensor assembly to the battery current sensor holder.


b.

Attach the clamp and connect the engine wire to the battery state sensor assembly.


c.

Connect the battery state sensor assembly connector.


d.

Install the battery state sensor assembly to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION