Home › Drivetrain › EG62 (MANUAL TRANSMISSION / TRANSAXLE) › SPEED SENSOR
RM3620E _52 Drivetrain _076270 EG62 MANUAL TRANSMISSION / TRANSAXLE _0371318 SPEED SENSOR G

EG62 MANUAL TRANSMISSION / TRANSAXLE  SPEED SENSOR  INSPECTION  


PROCEDURE

Hide 89413B 1.INSPECT TRANSMISSION REVOLUTION SENSOR

a.

Connect the battery to the transmission revolution sensor as shown in the illustration.

C405295C01
2.083,2 1.875,1.521 true 1.333,2 1.542,1.521 true 6.24,0.948 5.823,0.948 false 4.865,0.5 4.865,0.833 false 4.24,0.979 4.49,0.979 false 3.688,0.979 3.938,0.979 false 6.167,1.75 5.833,1.75 5.833,1.75 5.719,2.115 false 5.219,2.292 5,2.469 false 4.458,1.625 4.25,1.833 4.25,1.833 3.833,1.833 false 6.271,0.854 6.583,1.01 0.313,0.156 10 false *1 1.021,0.583 1.333,0.74 0.313,0.156 10 false *a 6.198,1.656 6.51,1.813 0.313,0.156 10 false *b 4.885,2.438 5.198,2.594 0.313,0.156 10 false *c 4.813,0.823 5.125,0.979 0.313,0.156 10 false *d 1.958,2.01 2.458,2.229 0.5,0.219 10 false NMO 1.167,2.01 1.625,2.208 0.458,0.198 10 false NMB 4.521,0.896 4.833,1.052 0.313,0.156 10 false 1 3.583,0.885 3.896,1.042 0.313,0.156 10 false 2 3.677,1.74 3.99,1.896 0.313,0.156 10 false *2
*1 Battery *2 Transmission Revolution Sensor
*a Component without harness connected
(Transmission Revolution Sensor)
*b Magnetic Object
*c 5 mm or less *d Ammeter



b.

Wave a magnetic object left and right in front of the transmission revolution sensor tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

NOTICE:

Make sure to wave the magnetic object during the inspection. The current will not change without waving the magnetic object as indicated by the arrow in the illustration.



c.

Measure the current according to the value(s) in the table below.

Standard Current:
Tester Connection Condition Specified Condition
1 (NMO) - 2 (NMB) Low signal 4 to 8 mA
High signal 12 to 16 mA