Be sure to correctly follow the removal and installation procedures for the airbag ECU assembly.
1.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
2.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
Visually check for defects with the airbag ECU assembly installed to the vehicle.
The defects are as follows:
Cracks on the ECU housing
Dents on the ECU housing
Chips on the ECU housing
Cracks or other damage to the connector
Peeling of the label
No defects are found.
If any defects are found, replace the airbag ECU assembly with a new one.
3.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
Replace the airbag ECU assembly.
The airbag ECU assembly should be replaced after any of the SRS parts has deployed as it has been subjected to an impact.