Home › General › MAINTENANCE › A25A-FKS DRIVE BELT
RM3620E _V1 General _076298 MAINTENANCE _0371459 A25A-FKS DRIVE BELT A

MAINTENANCE  A25A-FKS DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

HINT:

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.


a.
A400256C03
1.083,1.438 1.396,1.635 0.313,0.198 10 false *1 1.906,0.26 2.219,0.458 0.313,0.198 10 false *2 1.979,1.594 2.292,1.792 0.313,0.198 10 false *3
*1 Crankshaft Pulley Assembly
*2 Generator Assembly
*3 Compressor Assembly With Pulley


Set the V-ribbed belt onto each pulley as shown in the illustration.


b.

Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.


c.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.


Hide 53736E 2.INSTALL FRONT FENDER APRON SEAL RH