The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH removal/installation are shown below.
1.REMOVE FRONT DRIVE SHAFT ASSEMBLY
43420H
2.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43420H
3.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Inner Lip |
| *b | Outer Lip |
Using SST and a hammer, install a new front drive shaft oil seal LH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
| *a | Correct |
| *b | Incorrect |
| *c | Outer Lip |
Make sure that the outer lip of the front drive shaft oil seal LH is not pinched by SST.
Do not allow foreign matter to attach to the inner lip and outer lip of the front drive shaft oil seal LH.
Do not install the front drive shaft oil seal LH at an angle.
Do not remove the grease from the inner lip and outer lip of the front drive shaft oil seal LH.
4.INSTALL FRONT DRIVE SHAFT ASSEMBLY