73480
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
w/o Occupant Detection Sensor:
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH) |
for LH:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (LBR+) - 4 (LBR-) | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH) |
for CENTER:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (CBR+) - 3 (CBR-) | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
w/ Occupant Detection Sensor:
| *a | Connector A |
| *b | Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH) |
for LH:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N38-5 (LBR+) - A-1 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| N38-4 (LBR-) - A-2 | Always | Below 1 Ω |
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
| *a | Connector A |
| *b | Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH) |
for CENTER:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N39-4 (CBR+) - A-1 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| N39-3 (CBR-) - A-2 | Always | Below 1 Ω |
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
73380D
2.INSPECT REAR SEAT INNER BELT ASSEMBLY
w/o Occupant Detection Sensor:
| *a | Component without harness connected
(Rear Seat Inner Belt Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (RBR+) - 4 (RBR-) | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner belt assembly.
w/ Occupant Detection Sensor:
| *a | Connector A |
| *b | Component without harness connected
(Rear Seat Inner Belt Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N37-5 (RBR+) - A-1 | Seat belt unfastened | Below 1 Ω |
| Seat belt fastened | 10 kΩ or higher | |
| N37-4 (RBR-) - A-2 | Always | Below 1 Ω |
If the result is not as specified, replace the rear seat inner belt assembly.