Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › 2018.10–2020.08
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0372098 TELEMATICS SYSTEM(for eCall) M

TELEMATICS  TELEMATICS SYSTEM(for eCall)  REGISTRATION  


PROCEDURE

Hide 1. REGISTER VEHICLE INFORMATION

HINT:

If the telephone transceiver assembly has been replaced, it is necessary to perform the Register Vehicle Information procedure.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization

Body Electrical > Telematics > Utility
Tester Display
VIN Synchronization
50005 233 2391

e.

According to the display on the GTS, perform VIN Synchronization to register the VIN to the telephone transceiver assembly.


f.

Enter the following menus: Body Electrical / Telematics / Utility / ID Information Display


g.

According to the display on the GTS, read the IMEI, ICCID and VIN.


Hide 2. DCM ACTIVATION

HINT:
·

Before DCM activation, make sure to perform vehicle information registration.

·

Perform the activation outside to ensure GNSS signal is available.



a.

Turn the ignition switch to ON and confirm that the manual (SOS) switch illuminated indicators.


b.

Refer to the following chart and perform the appropriate procedure according to the illumination status of the manual (SOS) switch indicators.

Illumination Status of Manual (SOS) Switch Indicators Procedure
Illuminated red (10 sec.), green (2 sec.), then goes off
1.

Wait 80 seconds, and then press and hold the manual (SOS) switch for 3 to 10 seconds and check that a beep sound is heard.

2.

Wait 5 minutes.

NOTICE:

Do not press the manual (SOS) switch while waiting.


3.

Turn the ignition switch off.

4.

Turn the ignition switch to ON and check the illumination status of the manual (SOS) switch indicators.

If the indicators illuminate in the following pattern, activation is complete: red (10 sec.), green (2 sec.), red and green together, then only green stays illuminated.


Illuminated red (10 sec.), then stays green
1.

Wait 5 minutes.

NOTICE:

Do not press the manual (SOS) switch while waiting.


2.

Turn the ignition switch off.

3.

Turn the ignition switch to ON and check the illumination status of the manual (SOS) switch indicators.

If the indicators illuminate in the following pattern, activation is complete: red (10 sec.), green (2 sec.), red and green together, then only green stays illuminated.



HINT:

Depending on radio wave signal conditions, an activation may fail even though the vehicle is not malfunctioning.

If the indicators do not illuminate in the following pattern, perform the DCM activation procedure again: red (10 sec.), green (2 sec.), red and green together, then only green stays illuminated.



Hide 3.RESET MOBILEPHONE BATTERY CONDITION

HINT:

If the mobilephone battery has been replaced, it is necessary to perform the Backup Battery Replacement Reset Condition procedure.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Utility / Backup Battery Reset

Body Electrical > Telematics > Utility
Tester Display
Backup Battery Replacement Reset
50005 233 4392

e.

According to the display on the GTS, perform Backup Battery Replacement Reset to reset the mobilephone battery replacement flag.