17168
1.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Install the No. 2 exhaust manifold heat insulator to the exhaust manifold with the 6 bolts.
17141
2.INSTALL EXHAUST MANIFOLD
Install a new exhaust manifold to head gasket to the cylinder head sub-assembly.
Temporarily install the exhaust manifold, No. 1 exhaust manifold heat insulator and No. 1 upper front floor heat insulator.
At this time, do not install the parts with bolts or nuts.
Using a 12 mm deep socket wrench, temporarily install the exhaust manifold to the cylinder head sub-assembly with 7 new nuts.
Using the 12 mm deep socket wrench, tighten the 7 nuts in the order shown in the illustration.
17118
3.INSTALL MANIFOLD STAY
Temporarily install the manifold stay to the exhaust manifold and cylinder block sub-assembly with the bolt and nut.
Tighten the bolt and nut in the order shown in the illustration.
17167
4.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
| *a | Torque Wrench Fulcrum Length |
Using a 10 mm union nut wrench, install the No. 1 exhaust manifold heat insulator to the exhaust manifold with the 5 bolts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 8.8 N*m (90 kgf*cm, 78 in.*lbf)
58151
5.INSTALL NO. 1 UPPER FRONT FLOOR HEAT INSULATOR
Install the No. 1 upper front floor heat insulator to the vehicle body with the 2 nuts.
6.INSTALL WIRE HARNESS CLAMP BRACKET
Install the wire harness clamp bracket with the bolt.
89467B
7.INSTALL AIR FUEL RATIO SENSOR (for Sensor 1)
17410
8.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install 2 new gaskets to the front exhaust pipe assembly.
Connect the front exhaust pipe assembly to the 2 exhaust pipe supports.
Install the front exhaust pipe assembly to the exhaust manifold and tail exhaust pipe assembly with 2 new bolts and 2 new nuts.
| *a | Tie Band |
| *b | Wire Harness Clamp |
Connect the air fuel ratio sensor connector.
Attach the 2 wire harness clamps so that the tie band is positioned as shown in the illustration.
9.INSPECT FOR EXHAUST GAS LEAK
51468B
10.INSTALL ENGINE UNDER COVER HEAT INSULATOR
51420
11.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY