Home › Power Source / Network › A25A-FXS (BATTERY / CHARGING) › CHARGING SYSTEM
RM3620E _57 Power Source / Network _076184 A25A-FXS BATTERY / CHARGING _0372190 CHARGING SYSTEM L

A25A-FXS BATTERY / CHARGING  CHARGING SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the charging system have been removed/installed or replaced.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


·

When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system(s) after the cable is reconnected.

System Name See Procedure
Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Assist Monitor System
Pre-collision System




CHARGING SYSTEM PRECAUTION


CAUTION:
·
A340386

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·
A340358

To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.



NOTICE:
·

If the auxiliary battery is fully depleted or the READY indicator does not illuminate, recharge the auxiliary battery.

·

Never disconnect the auxiliary battery while the power switch is on (READY).

·

Before giving the auxiliary battery a quick charge, disconnect the auxiliary battery cables.

·

Check the auxiliary battery again before the vehicle is returned to the customer.

·

When replacing the auxiliary battery with a new one, use an auxiliary battery with the same physical dimensions, a collective ventilation system and a 20-hour rate (20 AHr) capacity of 55 Ah or more.