Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module)
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0372423 FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module) A

A25A-FXS EMISSION CONTROL  FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module)  REMOVAL  


PROCEDURE

Hide 58903A 1.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY

Hide 58325E 2.REMOVE REAR FLOOR SERVICE HOLE COVER

Hide 89461 3.REMOVE FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

a.
A433640

Disconnect the fuel tank pressure sensor (vapor pressure sensor) connector.


b.
A433639C01
1.573,2.417 1.771,2.417 1.771,2.417 1.99,2 true 0.771,3.635 1.615,3.635 true 0.854,3.885 1.49,3.885 false 2.219,3.469 2.854,3.469 false 2.26,3.021 2.896,3.021 false 2.938,2.927 3.25,3.083 0.313,0.156 10 false *1 0.677,3.792 0.99,3.948 0.313,0.156 10 false *2 2.906,3.375 3.219,3.531 0.313,0.156 10 false *3 0.604,3.521 0.917,3.677 0.313,0.156 10 false *a 1.385,2.333 1.698,2.49 0.313,0.156 10 false *3
*1 Fuel Tank Pressure Sensor (Vapor Pressure Sensor)
*2 Fuel Suction Plate Sub-assembly
*3 Tube Joint Clip
*a O-ring


Remove the tube joint clip and pull off the fuel tank pressure sensor (vapor pressure sensor) from the fuel tank assembly.

NOTICE:
·

Remove any dirt or foreign matter on the fuel tank pressure sensor (vapor pressure sensor) before performing this work.

·

Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tank pressure sensor (vapor pressure sensor) has an O-ring that seals the fuel suction plate sub-assembly.

·

Perform this work by hand. Do not use any tools.

·

If the fuel suction plate sub-assembly and fuel tank pressure sensor (vapor pressure sensor) are stuck, carefully wiggle or push and pull the fuel tank pressure sensor (vapor pressure sensor) to release it. Pull the fuel tank pressure sensor (vapor pressure sensor) off the fuel suction plate sub-assembly carefully.