Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › PCV VALVE
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0372426 PCV VALVE A

A25A-FXS EMISSION CONTROL  PCV VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PCV valve (ventilation valve sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Replacement of EGR valve assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(w/ Canister Pump Module)(Click here)
(w/o Canister Pump Module)(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 12204C 2.REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)

a.
A405807

Remove the PCV valve (ventilation valve sub-assembly) from the cylinder head sub-assembly.