Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY › 2018.10–2019.09
RM3620E _59 Vehicle Exterior _076526 SLIDING ROOF / CONVERTIBLE _0372469 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81208 1.INSPECT MAP LIGHT SUB-ASSEMBLY (for Panoramic Moon Roof)

a.

Check the sliding roof switch (map light sub-assembly).

i.
E303110C21
2.938,1.844 2.427,1.323 true 2.479,1.844 2.115,1.333 true 2.115,1.833 1.938,1.333 true 1.615,1.833 1.771,1.354 true 1.083,1.833 1.656,1.344 true 0.656,1.844 1.448,1.344 true 0.083,0.063 0.396,0.26 0.313,0.198 10 false *a 1.979,1.854 2.438,2.052 0.458,0.198 10 false OPN 2.406,1.854 2.865,2.052 0.458,0.198 10 false CLS 2.833,1.854 3.292,2.052 0.458,0.198 10 false GND 1.375,1.854 1.885,2.052 0.51,0.198 10 false DOWN 0.948,1.854 1.406,2.052 0.458,0.198 10 false UP 0.563,1.854 0.719,2.052 0.156,0.198 10 false B
*a Component without harness connected
(Sliding Roof Switch (Map Light Sub-assembly))


Measure the resistance between each terminal of the spiral cable sub-assembly according to the value (s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
14 (OPN) - 11 (GND) OPEN switch ON Below 100 Ω
OPEN switch OFF 10 kΩ or higher
13 (CLS) - 11 (GND) CLOSE switch ON Below 100 Ω
CLOSE switch OFF 10 kΩ or higher
17 (B) - 11 (GND) Tilt switch ON Below 100 Ω
Tilt switch OFF 10 kΩ or higher
16 (UP) - 11 (GND) Roof sunshade OPEN switch ON Below 100 Ω
Roof sunshade OPEN switch OFF 10 kΩ or higher
15 (DOWN) - 11 (GND) Roof sunshade CLOSE switch ON Below 100 Ω
Roof sunshade CLOSE switch OFF 10 kΩ or higher


If the result is not as specified, replace the sliding roof switch (map light sub-assembly).



Hide 81208 2.INSPECT MAP LIGHT SUB-ASSEMBLY (for Moon Roof)

a.

Check the sliding roof switch (map light sub-assembly).

i.
E303110C26
2.448,1.323 2.99,1.792 true 1.969,1.344 2.063,1.771 true 1.823,1.323 1.573,1.771 true 1.615,1.313 1.135,1.771 true 2.104,1.323 2.531,1.781 true 0.073,0.125 0.385,0.323 0.313,0.198 10 false *a 1.938,1.802 2.396,2 0.458,0.198 10 false OPN 2.875,1.802 3.333,2 0.458,0.198 10 false GND 1.365,1.802 1.969,2.031 0.604,0.229 10 false DOWN 1.021,1.802 1.479,2 0.458,0.198 10 false UP 2.427,1.792 2.885,1.99 0.458,0.198 10 false CLS
*a Component without harness connected
(Sliding Roof Switch (Map Light Sub-assembly))


Measure the resistance between each terminal of the spiral cable sub-assembly according to the value (s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
14 (OPN) - 11 (GND) OPEN switch ON Below 100 Ω
OPEN switch OFF 10 kΩ or higher
13 (CLS) - 11 (GND) CLOSE switch ON Below 100 Ω
CLOSE switch OFF 10 kΩ or higher
16 (UP) - 11 (GND) UP switch ON Below 100 Ω
UP switch OFF 10 kΩ or higher
15 (DOWN) - 11 (GND) DOWN switch ON Below 100 Ω
DOWN switch OFF 10 kΩ or higher


If the result is not as specified, replace the sliding roof switch (map light sub-assembly).