FRONT WIPER CONTROL FUNCTION
| Control/Function | Description |
|---|---|
|
*1: w/ Auto Wiper System *2: w/ Washer Nozzle Heater System |
|
| MIST function | Operates the front wipers in LO when the front wiper switch is held in the MIST position. |
| Intermediate position return function | Resumes wiper operation according to the operation of the front wiper switch or washer switch when the wipers are stopped in any position other than the lower reverse position. |
| Auto operation*1 | Operates the wipers as requested by the rain sensor when the windshield wiper switch assembly is in the AUTO position. |
| Vehicle speed sensing type adjustable intermittent wiper control | Controls the delay of the front wipers when the front wiper switch is in the INT position.
|
| Vehicle speed linked wiper operation control | Operates the wipers as follows when the vehicle is stopped.
·
When the vehicle speed is 5 km/h (3 mph) or lower and the intermittent time adjustment switch is in any position other than P4, if the front wiper switch is moved to the LO position, the wipers will operate in LO for 3 cycles and then at a 2.5 second interval. ·
When the intermittent time adjustment switch is in any position other than P4 and the front wiper switch is in the LO position, if the vehicle speed decreases to 5 km/h or lower, the wipers will operate in LO for 2 cycles and then at a 2.5 second interval.
|
| Protection mode | INT position:
Suspends wiper operation if the wipers are prevented from operating for 5 seconds or more, in order to protect the wiper and washer system. Lo, Hi position: Suspends wiper operation if the wipers are prevented from operating for 10 seconds or more, in order to protect the wiper and washer system. |
| Washer nozzle heater*2 | ·
Operates the washer nozzle heater system when the ambient temperature is 5°C (41°F) or less while the ignition switch is ON. ·
Stops the washer nozzle heater system when the ignition switch is turned off. ·
Stops the washer nozzle heater system when the ambient temperature reaches 6°C (42°F) or higher while the ignition switch is ON. |
REAR WIPER CONTROL FUNCTION
| Control/Function | Description |
|---|---|
|
*: w/ Reverse Position Inter |
|
| Back door open linked wiper suspend function | Suspends rear wiper operation when the back door is opened.
|
| R shift position auto rear wiper operation function* | Operates the rear wiper 0.4 seconds after the shift lever is moved to R when the front wipers are operating.
|
WASHER CONTROL FUNCTION
| Control/Function | Description |
|---|---|
|
*1: w/ Washer Level Switch *2: w/ Headlight Cleaner System |
|
| Front washer cooperation | ·
When the washer switch is held in the Fr WASH position for 0.5 seconds or more, the front wipers operate in LO. ·
When the washer switch is released, the front wipers operate in LO for 3 additional cycles.
|
| Rear washer cooperation | ·
When the washer switch is held in the Rr WASH position for 0.5 seconds or more, the rear wiper operates. ·
When the washer switch is released, the rear wiper operates in LO for 2 to 3 additional cycles.
|
| Drip prevention wiper function | Approximately 3 seconds after front washer cooperation completes, operates the wipers for 1 cycle to remove any remaining washer fluid.
|
| Washer fluid level low warning*1 | Displays "Windshield Washer Fluid Low" on the multi-information display in the combination meter assembly when the washer fluid level is low. |
| Headlight cleaner control*2 | With the ignition switch ON and the headlights illuminated, the windshield wiper switch assembly (washer switch) operates the headlight cleaner motor and pump assembly the first time and every fifth time it is turned on, and washer fluid is sprayed from the headlight washer actuator sub-assembly for approximately 1.5 seconds. |